Inoperative Right Front Door Switches – 2004-2008 Chrysler Pacifica

“This site contains affiliate links for which OEMDTC may be compensated”

NUMBER: 08-021-08
GROUP: Electrical
DATE: May 24, 2008

 

SUBJECT:

Inoperative Right Front Door Switches

 

OVERVIEW:

This bulletin involves replacing the right door interior handle. The loss of ALL functions may occur when attempting to control them from any of the switches located on the right door due to electrostatic discharge through the right door interior handle. The right door interior handle must be replaced to protect the switch module from static electricity. The new handle is more resistant to electrostatic discharge.

 

MODELS:

2004 – 2008 (CS) Pacifica

 

SYMPTOM/CONDITION:

The vehicle operator may experience a permanent loss in ability to actuate ALL of the following functions from the right door switches:

 

DIAGNOSIS:

Perform a “Hard Reset” of the right door switch module. This may be accomplished by removing all power (including memory keep alive power) from the right door switch module by unplugging the module power connector. Alternatively, vehicle power may be interrupted by removing the negative battery terminal when the ignition switch is in the OFF position. If after performing the hard reset functions of the right door switches return, perform the Repair Procedure.

 

PARTS REQUIRED:

Qty. Part No. Description
1 68039248AA Kit, Resistant Handle (Includes Instruction Sheet)
1 (AR) 04549615 Lubricant, Lubriplate
(1 tube will service multiple vehicles)

 

REPAIR PROCEDURE:

  1. Disconnect the negative battery cable.
  2. Remove the right door trim panel. Refer to the service information in TechCONNECT. Refer to 23 – Body > Door – Front > Trim Panel > Removal.
  3. Remove the door tweeter speaker. Refer to the service information in TechCONNECT. Refer to 8 – Electrical > Audio > Speaker > Removal ( 1).

 

Fig. 1 TWEETER SPEAKER (Left Shown, Right Similar)

1 – DOOR TRIM PANEL
2 – TWEETER SPEAKER

 

  1. Remove the power seat switch. Refer to the service information in TechCONNECT. Refer to 8 – Electrical > Power Seats > right Seat Switch > Removal.
  2. Replace the right door interior handle, p/n 05170261AA, as described on Mopar Instruction Sheet K6855628 included in the handle kit.
  3. Install the power seat switch.
  4. Install the door tweeter speaker.
  5. Install the right door trim panel.
  6. Connect the negative battery cable.

 

POLICY:

Reimbursable within the provisions of the warranty.

 

TIME ALLOWANCE:

Labor Operation No: Description Amount
08-80-77-93 Kit, Right Door Handle and Switch, Replace (B) 0.4 Hrs.

 

FAILURE CODE:

ZZ Service Action

 

Loader Loading...
EAD Logo Taking too long?

Reload Reload document
| Open Open in new tab

Download [5.78 KB]

 

 

Leave a Comment

Share to...