“This site contains affiliate links for which OEMDTC may be compensated” |
NUMBER: 09-004-07
GROUP: Engine
DATE: September 25, 2007
SUBJECT:
Engine Cranks But Will Not Start
OVERVIEW:
This bulletin involves checking for Camshaft and Crankshaft Synchronization using a StarSCAN. Checking the Julian date on the sensor and if necessary, replacing Crankshaft Position Sensor.
MODELS:
2006 – 2007 | (LE) | 300C/300C Touring (International Markets) |
2007 | (WK) | Grand Cherokee |
2005 – 2007 | (WH) | Grand Cherokee (International Markets) |
2006 – 2007 | (XH) | Commander (International Markets) |
NOTE: This bulletin applies to the above listed vehicles equipped with a 3.0L Diesel engine (sales code EXL) built before the following dates:
- (LE) built before March 29, 2007 (MDH 0329XX)
- (WH) built before March 28, 2007 (MDH 0328XX)
- (WK) built before June 12, 2007 (MDH0612XX)
- (XH) built before March 28, 2007 (MDH 0328XX)
SYMPTOM/CONDITION:
The engine cranks but will not start.
DIAGNOSIS:
- Using a StarSCAN, check for Camshaft/Crankshaft Synchronization.
- Does the StarSCAN display: “Not in Sync” ?
- Yes >>> Proceed to Step #3.
- No >>> This bulletin does not apply, further diagnosis is required.
- Remove the Crankshaft Position Sensor and heat shield using the service information available in DealerCONNECT > TechCONNECT > 14 – Fuel System > Fuel Injection Diesel > Sensor-Crankshaft Position > Removal ( 1).
- Inspect the Crankshaft Position Sensor for the Julian date. The Julian date is located on the sensor opposite side from the hold down flange (just above mounting surface).
- An example of a Julian date on the sensor reads as follows: 07 T 59
07 represents the year, 59 represents the day, (59th day of 2007).
- An example of a Julian date on the sensor reads as follows: 07 T 59
- Is the Julian date 07 T 59 or lower?
- Yes >>> proceed to Repair Procedure.
- No >>> Reinstall original Crankshaft Position Sensor. This bulletin does not apply, further diagnosis is required.
Fig. 1 CRANKSHAFT POSITION SENSOR
1 – HEAT SHIELD
2 – CRANKSHAFT POSITION SENSOR
PARTS REQUIRED:
Qty. | Part No. | Description |
---|---|---|
1 | 05175763AB | Sensor, Crankshaft Position |
REPAIR PROCEDURE:
- Replace the Crankshaft Position Sensor using (p/n 05175763AB) Installation procedures available in DealerCONNECT > TechCONNECT > 14 – Fuel System > Fuel Injection – Diesel > Sensor-Crankshaft Position > Installation.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No: | Description | Amount |
---|---|---|
08-15-79-94 | Sensor, camshaft position – Inspect & Replace (B) | 0.3Hrs. |
FAILURE CODE:
ZZ | Service Action |
Loading...